diff options
| -rw-r--r-- | case_base.scad | 45 |
1 files changed, 32 insertions, 13 deletions
diff --git a/case_base.scad b/case_base.scad index c1a7797..0e23a82 100644 --- a/case_base.scad +++ b/case_base.scad @@ -26,11 +26,13 @@ clip_tolerance = 0.5; clip_bottom_width = 10; clip_top_width = 15; -// should be aroung 7, since we use 1GF unit as base. -clip_mount_resulting_offset = 8.5; -clip_bottom_angle = 220; -clip_top_angle = 160; +// This is basically the height +clip_mount_resulting_offset = 9; +clip_bottom_angle = 225; +clip_top_angle = 150; clip_handle_length = 8; +clip_handle_angle = 30; +clip_straight_part = 4; module top_block(units_x, units_y,) { @@ -73,15 +75,31 @@ module round_clipper(angle, width) { module clip(units_z) { resulting_height = units_z*7 + clip_mount_resulting_offset; + straight_part=clip_straight_part; + straight_offset = resulting_height - straight_part; linear_extrude(clip_thickness) { - polygon([[0,0],[clip_bottom_width,0], - [clip_width/2 + clip_top_width/2,resulting_height], - [clip_width/2 - clip_top_width/2,resulting_height] ]); - - polygon([[clip_width - clip_bottom_width,0],[clip_width ,0], - [clip_width/2 + clip_top_width/2,resulting_height], - [clip_width/2 - clip_top_width/2,resulting_height] ]); + polygon([[0,straight_part],[clip_bottom_width,straight_part], + [clip_width/2 + clip_top_width/2,straight_offset], + [clip_width/2 - clip_top_width/2,straight_offset] ]); + + polygon([[clip_width - clip_bottom_width,straight_part],[clip_width ,straight_part], + [clip_width/2 + clip_top_width/2,straight_offset], + [clip_width/2 - clip_top_width/2,straight_offset] ]); + + //Straight end Bottom + polygon([[0,0],[clip_bottom_width,0],[clip_bottom_width,straight_part],[0,straight_part]]); + + polygon([[clip_width - clip_bottom_width,0],[clip_width ,0], + [clip_width ,straight_part],[clip_width - clip_bottom_width,straight_part]]); + + // straight end Top + polygon([ + [clip_width/2 + clip_top_width/2,straight_offset], + [clip_width/2 - clip_top_width/2,straight_offset], + [clip_width/2 - clip_top_width/2,resulting_height], + [clip_width/2 + clip_top_width/2,resulting_height], + ]); } round_clipper(-clip_bottom_angle, clip_bottom_width); @@ -91,8 +109,9 @@ module clip(units_z) { translate([clip_width/2 - clip_top_width/2, resulting_height,0]) { round_clipper(clip_top_angle,clip_top_width); // Handle - translate([0,-clip_thickness,-clip_handle_length]) - cube([clip_top_width,clip_thickness,clip_handle_length]); + translate([0,0,sin(clip_handle_angle)*clip_thickness]) rotate([clip_handle_angle,0,0]) + translate([0,-clip_thickness,-clip_handle_length]) + cube([clip_top_width,clip_thickness,clip_handle_length]); } } |